Mahr
Mahr
Technical Articles
EN-US
Teaser Bild
October 2019
Mahr Inc., a provider of dimensional metrology solutions, will highlight its line of optical manufacturing measurements solutions in booth #1221 at Spie Optifab 2019.
Teaser Bild
July 2018
More than any other field, IIoT overlaps directly with metrology’s mission of analyzing and measuring as much of the manufacturing process as possible, and it’s no surprise that the latter is utilizin
Teaser Bild
July 2018
Form is a relatively easy thing to measure in many senses. In the simplest manner, form measurement involves a probe or stylus being moved along an ideal circular or linear path to gather data on the
Teaser Bild
April 2018
For patients, high quality orthopedic components mean that implants can be kept for as long as possible, reducing or even eliminating the need for further procedures down the road.
Teaser Bild
2016-06-02
A manufacturer of sub-surface oil well pump barrels needed a better way to check the inside of their barrels for wear. Read this case study to see how MarSolutions solved this problem.
Teaser Bild
2016-06-02
View a collection of case studies showing different MarSolutions gages engineered for specific applications in the Machine Tool industry.
Teaser Bild
2016-06-02
View a collection of case studies showing different MarSolutions gages custom built for specific applications.
Teaser Bild
2013-11-13
Most gages on the shop floor provide a specified level of accuracy in conditions for which they were designed. But in the production environment, where tight tolerances are a way of life, it’s critical to think about gaging requirements before putting instruments out there and possibly having them not meet expectations.
Teaser Bild
2013-09-25
These standards may have a significant impact on how some companies specify, measure and manufacture parts.
Teaser Bild
2013-08-28
A manufacturer of orthopedic implants needed to improve measurement and documentation proficiency of parts with literally hundreds of configurations. Air gaging was desired because it can quickly and accurately measure precision tapers.
Teaser Bild
2013-08-20
Traditionally the length of a production run was a key factor in the selection of a dimensional gaging system. Typically, the higher the production run, the more cost effective a dedicated or customized gaging system was likely to be, while shorter runs would require greater flexibility and versatility in gaging. A dedicated gage would be faster, more accurate, and least subject to operator influence, but would also likely be more expensive.
Teaser Bild
2013-07-08
Mahr is a specialist in production quality assurance for turbochargers. The tolerances of the various components of a turbocharger can be safely and accurately checked with Mahr’s measuring solutions.
Teaser Bild
2013-05-08
A manufacturer of sub-surface oil well pump barrels needed a better way to check the inside of their barrels for wear. The barrels, some up to 30 feet long, must be periodically removed from the well and checked for excessive wear due to constant plunger motion.
Teaser Bild
2013-04-22
The term “shaft measurement system” is standard industry parlance today, but to think of these gages as measuring only shafts is too limiting. For the most part, anything created as a turned part on a lathe is probably well suited for these devices. If there are features such as diameters, lengths, groove widths, fillet radii or chamfers on the part then it is well suited for measurement by a shaft measurement system.